This is the final phase for garage prep prior to ordering the GTM chassis. I installed a
Swisstrax floor at the build site. In the post entitled
Synergy I discussed Swisstrax flooring. If you decide to install a floor like this,
list Traci as your sales person. She has handled 4 orders for me, and they all arrived perfect.
|
Finished product. The Maple Grove build site for the GTM. |
Neither the Swisstrax floor or the
DirectLift car lift are requirements for the GTM. They are both designed to make the build space more usable. The Swisstrax floor is virtually indestructible. It doesn't mar from jack stands or ramps. It doesn't come apart when a car drives on/off repeatedly. It doesn't fade under bright sun (and South Carolina has plenty of that). It doesn't scratch your painted parts.
|
DiamondTrax tile. |
Each tile is a mixture of polymers and rubber, and each tile has a compression strength of 5120 psi. This floor is more forgiving than concrete, and I have no illusions - things will get dinged and nicked during the build. Hopefully, the Swisstrax floor will mitigate some of my clumsiness.
|
This is the bottom of a tile. You can see it is designed to handle a significant load. In my case, the weight of the lift is dispersed to four load points and the weight of any car I might put on there is equally distributed to those load points. The lift weights 1700 lbs and the heaviest car I might put up there is 4000 lbs. That comes down to 1600 lbs per load point - well within spec for the titles. |
I chose the DiamondTrax pattern, because it provides grip and prevents things from just wandering away. It is available in
fourteen colors. Once you've selected the product and have measurements, go to the
floor designer and build your floor. The designer is a HTML WYSIWYG tool. When you're satisfy request a quote. Get the estimate, pay the bill and wait for FedEx truck to arrive.
|
Th edge pieces are about 2 inches wide and provide a nice ramp edge to the floor. |
Assembly is a snap. The tiles fit together per the plan you submitted. For tools you need some gloves, knee pads, rubber mallet and a cutting tool (I'd suggest the
Dremel Multi Max or one of its clones). I finish off the job with end pieces to give me a tapered edge.
No comments:
Post a Comment